[Back][Shopping Cart][Search][Storefront]



[A2D Solutions - TVProRacks]

DDB Unlimited OD-30DXC-BAC

Outdoor Enclosures / Cabinets




[Image: DDB Unlimited OD-30DXC-BAC]

HomeAbout A2DContact A2DLinksPoliciesSearchEmail






DDB Unlimited

The OD-30DXC is the superior design in communication cabinets, being as rigid as steel & yet noticeably lighter than the old heavy steel constructed cabinets. This is made possible with our own aluminum recipe called ALUMIFLEX. The OD-30DXC offers the protection needed for any severe outdoor environment. The OD-30DXC is constructed of .125 ALUMIFLEX material, & comes with an additional .125 ALUMISHIELD top cover, thereby fully protecting your equipment from falling ice and the sun's heat penetration. Ultimate security is provided by a three point locking system, which utilizes NEMA stainless steel padlocking handles. The OD-30DXC, made of ALUMIFLEX, will operate without affecting or being effected by RF influences. Outdoor cabinets are becoming the alternative shelter solution for today's complicated zoning requirements. So whether your installing a new shelter or adding room to your existing one, the OD-30DXC is the ultimate solution.

Alumishield Top cover, shadescabinet from the sun
Handles Stainless steel - NEMA
Rails Fully adjustable &alodine coated
Doors Front and rear securedwith three point locks and padlocking handles
Vents Front & rear, top& bottom, filters supplied
Rails1 set of 19"rails standard

Specifications

General

Weight90 lbs. assembled
130 Lbs. Shipping weight
DoorsTwo - secured by three pointlocking system
Locks via customer supplied padlocks
sealed with 13/16" aluminum filled gaskets
Material.125 ALUMIFLEX
Finish: Flat aluminum
RF properties: Non-ferrous
Vents30 bottom louvers per door
Twelve top louvers - In top cover-under ALUMISHIELD
One removable filter panel per door
Twelve fixed filter pads in top cover
HandlesStainless steel, padlocking
Exterior ScrewsStainless withNEMA washers & nylon locking nuts

Racking Specifications

RailsTwo standard (For additionalrails see accessories)
Alodine coated
Holes tapped to 10 x 32 threads
Each rail supported by two R-STRUTS
.125 material (ALUMIFLEX)
Spacing19" EIA STANDARD
PositioningAll rails fully adjustablefrom front to rear
Useable Height30 inches
Useable DepthMaximum: 211/2" Minimum: 19 3/4" (See below)

*Section Starting & Ending PointsVertical Height Per sectionEffective Depth For Each Section
Top26.75" - 30.00" 3.25"21.50"

26.57" - 26.75"  .18"20.50"

21.00" - 26.57" 5.57"21.50"
    
Center9.00" - 21.00" 12.00"19.75"
    

3.43" - 9.00" 5.57"21.50"

3.25" - 3.43"  .18"20.50"
Bottom0.00" - 3.25" 3.25"21.50"
*Section measurements start from the bottom of the cabinet (0.00")
& run vertically upward towards the top of the cabinet (30.00")

Door Opening Clearance

Height25 13/16 inches
Width19 1/2 inches

Exterior Cabinet Dimensions

Main BodyWidth: 25 1/2 inches
Height: 30 1/4 inches
Depth: 25 1/4 inches
AlumishieldWidth: 28 inches
Hang down height: 1 3/4 inches
Depth: 27 1/2 inches
HandlesProtrude 1 7/8 inches
Total Space OccupiedWidth: 28 inches
Height: 30 1/2 inches
Depth: 29 inches

Inside Clearance - Less Rails

Width23 5/8 inches
Height30 inches
DepthSee rackingspec's - useable depth chart above

Ratings

NEMAClass 250 Type 4
Paint Tested500 Hour saltspray
 500 hour immersion

Warranty

PeriodSeven Years -Unconditional

Accessory Options

R-2-30:Two extra 30" rails andmounting hardware
MTDX:Mounting tray
CA-4:Caster kit (4) &mounting hardware
SCR-432:Rail Screws (4)10x32

Climate Control Options

Air Conditioners viewall options
Heater Options viewall options
AC & DC Fan Kits viewall options

Shipping Information

StandardThe OD-30DX isshipped fully assembled, but can easily be knocked down and reassembledat your site, if desired.




[DOCUMENT:*HTM*]

  
DDB Unlimited OD-30DXC-BAC
Outdoor Enclosures / Cabinets

 

Item#

 

OD-30DXC-BAC_2CALL0.00

DDB Unlimited OD-30DXC-BAC
  

[Previous Product][Next Product]




 

[GO] 

 

[GO] 

These WWW pages ©2008 A2D Solutions - TVProRacks. All Rights Reserved.
A2D Solutions, Inc.   OLMG v2.02 ©1998-2000 The Fedele Group of Companies