A2D Solutions - TVProRacks : DDB Unlimited : DDB Unlimited 2OD-50DXC

DDB Unlimited 2OD-50DXC

Custom Order Cabinets

DDB Unlimited

The 2OD-50DX is the superior design in communication cabinets, being as rigid as steel & yet noticeably lighter than the old heavy steel constructed cabinets. This is made possible with our own aluminum recipe called ALUMIFLEX. The 2OD-50DX offers the protection needed for any severe outdoor environment. The 2OD-50DX is constructed of .125 ALUMIFLEX material, & comes with an additional .125 ALUMISHIELD top cover, thereby fully protecting your equipment from falling ice and the sun's heat penetration.

Ultimate security is provided by a three point locking system, which utilizes NEMA stainless steel padlocking handles. The 2OD-50DX made of ALUMIFLEX, will operate without affecting, or being effected by, RF influences. Outdoor cabinets are becoming the alternative shelter solution for today's complicated zoning requirements. So whether you're installing a new shelter or adding room to your existing one, the 2OD-50DX is the ultimate solution.

Alumishield Top cover, shadescabinet from the sun
Handles Stainless steel - NEMA
Rails Fully adjustable &alodine coated
Doors Front and rear securedwith three point locks and padlocking handles
Vents Front & rear, top& bottom, filters supplied

Top Of Page

Specifications

General

Weight

255 lbs. assembled
345 Lbs. Shipping weight

Doors

Four - secured by threepoint locking system
Locks via customer supplied padlocks
Sealed with 13/16" aluminum filled gaskets

Material

.125 ALUMIFLEX
Finish: Flat aluminum
RF properties: Non-ferrous

Vents

30 bottom louvers per door
24 top louvers - In top cover-under ALUMISHIELD
One removable filter panel per door
24 fixed filter pads in top cover

Handles

Stainless steel, padlocking

Exterior Screws

Stainless steelwith NEMA washers & nylon locking nuts

Racking Specifications

Rails

Eight standard (Foradditional rails see accessories)
Alodine coated
Holes tapped to 10 x 32 threads
Each rail supported by three R-STRUTS
.125 Material (ALUMIFLEX)

Spacing

19" EIA STANDARD

Positioning

All rails fully adjustablefrom front to rear

Useable Height

50 inches

Useable Depth

Maximum: 21.50"Minimum: 19.75" (See below)

	*Section Starting & Ending Points	Vertical Height Per section	Effective Depth For Each Section
Top	46.75" - 50.00"	3.25"	21.50"
	46.57" - 46.75"	.18"	20.50"
	31.00"- 46.57"	15.57	21.50"

Center	19.00"-31.00"	12.00"	19.75"

	3.43"-19.00"	15.57	21.50"
	3.25" - 3.43"	.18"	20.50"
Bottom	0.00" - 3.25"	3.25"	21.50"